Simple Pump header: Logo and slogan - 'The Modern Water Well Pump'.

CSS Pop Up Menus Css3Menu.com

Installation Instructions for the MOTORIZED Simple Pump System
(Scotch Yoke Drive option)
page 4

Section 3: Remove Handle

Once proper pumping function is confirmed, remove all hardware on the top of the pump head.


Remove the lever arm mechanism:

Using the 3/16" Allen wrench, remove each of the four fasteners holding the lever arm mechanism to the pump head.

Close-up of Simple Pump head. Showing removal of lever arm bracket screws.

Remove the lever arm bracket and lever (they should still be connected) from the 3/4" stainless rod.

The direction you screw is the opposite of normal -- turn clockwise to remove, rather than the normal counterclockwise.

Removing lever arm itself.

Push the pump rod fully down. The length of the white arrow in the picture should be no higher than 3-3/4" from the top of the stainless steel rod down to the shoulder (metal top) of the head (right).

If this is not the case, an adjustment in pipe length may be required.

Position the pump rod fully down.

next page




GET A QUOTE | DEALERSHIP QUERIES | SEND A MESSAGE

SIMPLE PUMP COMPANY, LLC
1140 Amarillo Drive, Gardnerville, Nevada 89460-7504