Simple Pump header: Logo and slogan - 'The Modern Water Well Pump'.

CSS Pop Up Menus Css3Menu.com

Installation for the Simple Pump hand pump continued...

Continue Drop Pipe Installation


Install the second drop pipe. As before, apply 3 wraps on the male threads (previously shown).

Then, arch the sucker rod so that its end is inserted into the male end of the drop pipe (right).

Threading drop pipe over arched sucker rod.

Screw the drop pipe ends together, 5/8 inches of engagement, or a half-rotation beyond hand-tight.

After connecting the drop pipe, lift up the drop pipe and remove the safety tool. Lower the drop pipe a few inches and replace the safety tool around the next drop pipe. Carefully lower the drop pipe until the next bell end is resting in the safety tool.

Tightening one drop pipe into the next.


You have installed the first two drop pipe kits. If you have more than twelve drop pipe kits, read the next optional section, on page 9.

Continue the addition of drop pipe kits — rod guide, then sucker rod, then drop pipe.

If you have less than twelve drop pipe kits, just past that to halfway down the next page -- “TESTING FOR WATER”.


Next page




GET A QUOTE | DEALERSHIP QUERIES | SEND A MESSAGE

SIMPLE PUMP COMPANY, LLC
1140 Amarillo Drive, Gardnerville, Nevada 89460-7504
Phone: 877.492.8711 (toll free) or 775.229.8175
Mon-Fri 8-5 Pacific Time