Simple Pump header: Logo and slogan - 'The Modern Water Well Pump'.

CSS Pop Up Menus Css3Menu.com

Appendix 2 continued

REPLACING the ROD GLAND

If you have the short rod gland

Remove the rod gland from the stainless pump head using the channel locks (counter-clockwise to loosen). Leave the o-ring in place beneath rod gland in pump head.

Thread in the new rod gland.

Install clevis onto 3/4" stainless rod (COUNTER-CLOCKWISE to tighten).

Install the (4) 1/4-20 x 1/2 shcs that affix the lever bracket to the pump head.

Position of washers and rod gland in pump head.If you have the long rod gland

It will be replaced by the short rod gland and guide.

REMOVE LONG ROD GLAND

Remove the pump head as described in “Changing the Pump Head Seals”.

The long rod gland runs the length of the assembly at length (middle arrow, left).

Remove the spider (lowest arrow) by unscrewing COUNTER-CLOCKWISE to loosen.

Remove the rod gland from the stainless pump head using the channel locks. Again, COUNTER-CLOCKWISE to loosen. Leave the o-ring in place beneath rod gland in pump head.

INSTALL PRESS-FIT GUIDE

Install the guide as shown in the four photos below.

Place guide in opening of riser tube.

A mark is made on some PVC tubing at the 6.5” mark.

The guide can then be pushed the correct distance into the riser tube.



INSTALL SHORT ROD GLAND

Thread the short rod gland into the top of the pump head.

REINSTALL PUMP HEAD AND HANDLE

Install pump head onto riser (COUNTER-CLOCKWISE to tighten).

Install clevis onto 3/4" stainless rod (COUNTER-CLOCKWISE to tighten).

Install the (4) 1/4-20 x 1/2 shcs that affix the lever bracket to the pump head.




GET A QUOTE | DEALERSHIP QUERIES | SEND A MESSAGE

SIMPLE PUMP COMPANY, LLC
1140 Amarillo Drive, Gardnerville, Nevada 89460-7504
Phone: 877.492.8711 (toll free) or 775.229.8175
Mon-Fri 8-5 Pacific Time